Guest Post: DIY Faux Crown Molding by Hi Sugarplum
You are going to love today's feature post! Cassie over at Hi Sugarplum has a beautiful home and she's worked hard to make it shine! This fun tip is mind blowing! After you see this post be sure to jump on over and see the rest of her magic all on display!
Are you ready to be
A major component in Babygirl's Room is complete....the Faux Crown Molding!!
Love it? What if I told you the total cost was $30?!? Now you're impressed! Here's the 'How-To.'
I'll save you oodles of time wandering the aisles of Home Depot, while on the phone describing every possible option to your aunt, and just tell you what to get!
This 1-inch trim is literally like a condensed foam (you could dent it with your fingernail), weighs virtually nothing, comes in 8-foot strips, and costs $2.38 each!
First measure the perimeter of your room, then double it (for two rows of trim). Then divide that number by 8 (length of each trim piece). That's how many pieces of trim you'll need. I needed 95 feet, or 12 pieces, for a total cost of $29! I was feeling spendy and picked up an extra piece in case I goofed.
I'll help you out again and tell you that even though these things are light as a feather, they do not want to be glued to the wall (even if you tape them in place and curse them up and down). But since they are so lightweight, and not a solid material, a simple finishing nail with a little teeth is all you need to adhere them to the wall.
Most average rooms will require very few cuts since there are 4 straight walls and these pieces are so long. Babygirl's Room has a bit of an alcove where the door is, so we had some smaller sections to contend with.
First I started with a full 8-foot piece andhung it by tapping in a nail every 18-24 inches. I did this on all the main walls and was leftwitha singlespace on each wallthatrequired a smaller piece (plus the alcove).
To cut smaller pieces, simply measure the space and follow this pictorial demonstrated by my cute helper:
Don't worry if it's not a completely clean break. Mr. Sugarplum rubbed a little spackle (so much easier than caulk) over the seams to bridge the gaps, then lightly sanded it down once dry. I didn't bother covering the nails since they are white and teeny-tiny, you don't even see them from the floor.
Of course I found some discrepancies in the wall and the trim bowed in a few spots. No problem, just tap in a nail and it will lay flat.,
A few trips up-and-down the ladder, and Voila!
I could have left it with just the stripe and it'd have a similar effect. But the trim gives it a little heft and dimension.
Here's the process again (read about it here and here):
I am thrilled with the outcome. I think it gives her room the added interest I was looking for, and my mishap became a blessing in disguise because I'm in love with the painted ceiling!
True I could have installed a traditional crown molding...but it would have cost a lot more, and been extremely labor intensive (anything requiring a saw becomes too laborious for me!) My investment for this project was $30 in materials and a couple hours of time. And the trim pops out pretty easily and leaves only a pin hole if I change my mind later.
Here's the door alcove I mentioned (and a glimpse into the Dining Room, where drapery samples are taped up!)
I love the mirror hanging over her door...itreminds meof a transom, and reflects the beautiful ceiling! I'm forcing myself to
So what do you think of my Faux Crown Molding?Do you have anyfaux treatments in your home?
View this article at Blue Cricket Design »
McGee Plumbing A C & Heating
excessive hourly rates
Replaced a customer provided water heater in attic. Watch out for their ex... Read More
Published by tjbinno